Keysight U1177A - Install and Replace the Batteries

5
Connect a Multimeter to the Keysight GUI Data Logger via the U1177A
1. Open the Keysight GUI Data Logger.
2. In the Communication Setting panel, the setup mode is set to Auto by default.
Click Connect Meter to establish the multimeter connection.
3. The multimeter will remain connected until the COM port is closed or the
U1177A is turned off.
• If you wish to set up the multimeter connection manually, select Manual
from the Communication Setting panel. Make sure you select the COM
port your multimeter is connected and set the baud rate, parity, and data
bit to the default conguration.
• Only one host computer is able to connect to the U1177A at a time.
Install and Replace the Batteries
Make sure you turn off the U1177A before installing or replacing
the batteries.
To avoid the U1177A being damage from battery leakage:
• Always remove dead batteries immediately.
• Always remove the batteries and store them seperately if the adapter is not
going to be used for a long period.
Slide the battery cover away from
the adapter’s body.
Insert the battery. Reverse the sliding position to
close the battery cover.