Keysight U1271A - Page 13

Keysight U1271A/U1272A Quick Start Guide 13
Keysight U1271A/U1272A Quick Start Guide 13
ENGLISH
Resistance measurements
Set up your multimeter as shown in the figure
below to perform resistance measurements.
Smart Ω measurements (U1272A only):
– Use the Smart Ω function to measure resistors
affected by DC offset or leakage current.
– If DC offset or bias voltages are detected on
the resistor-under-measure, the offset or bias
DC voltage value will be shown on the
secondary display. If the DC voltage on the
resistor is over +1.25 V, is shown on the
secondary display.
While performing resistance
measurements, press until
is shown on the display to
enable the Smart Ω function.
S
h
i
f
t
V
i
e
w
E
s
c