Keysight U1271A - Page 14

14 Keysight U1271A/U1272A Quick Start Guide
14 Keysight U1271A/U1272A Quick Start Guide
ENGLISH
Continuity tests
Set up your multimeter as shown in the figure
below to perform continuity tests. Press to
switch to the continuity test function ( is shown
on the display).
You can set the beeper to sound and the
backlight to flash as a continuity indication
whether the circuit-under-test is less than (short)
or more than or equal to (open) the threshold
resistance.
Press to switch between short ( ) and open
( ) states for checking NO (normal open) and
NC (normal close) contacts.
S
h
i
f
t
V
i
e
w
E
s
c
Exit
Dual
ON
(closed)
OFF
(open)
NOTE
The continuity function detects intermittent shorts
and opens lasting as short as 1 ms. A brief short or
open causes the multimeter to emit a short beep
and flash.