50 Keysight X-Series Signal Generators Error Messages
Error Messages
List of Error Messages
-222 Data out of range
A legal program data element was parsed but could not be
executed because the interpreted value was outside the legal
range defined by the device (see IEEE 488.2 11.5.1.1.5).
-222 Data out of range; A burst fall shape must have at least two points.
Two points are needed to specify a fall shape in the MEM:DATA:SHAPe
command.
-222 Data out of range; A burst rise shape must have at least two points.
Two points are needed to specify a rise shape in the MEM:DATA:SHAPe
command.
-222 Data out of range; A burst shape can only have up to {value} points
for the fall shape.
The user has specified more than the maximum number of points
allowed for the fall shape in the MEM:DATA:SHAPe command.
-222 Data out of range; A burst shape can only have up to {value} points
for the rise shape.
The user has specified more than the maximum number of points
allowed for the rise shape in the MEM:DATA:SHAPe command.
-222 Data out of range; A differential mapping can only have up to 256
states.
The user has specified more than 256 states in the MEM:DATA:IQ or
To Next Page
Loading...
