Ki Mobility Focus CR - V. Anti-Tips

42
V. SET UP & USE OF YOUR WHEELCHAIR
V. Anti-Tips
1. Flipping Anti-Tips Up
a. Pull anti-tip (Fig. 48:A) rearward to disengage rotary lock studs (Fig. 48:B).
b. Rotate anti-tip upwards.
c. Reset anti-tip back onto rotary lock studs, ensuring studs are nested into alignment slots.
2. Removing Anti-Tips
a. Depress buttons (Fig. 48:C) on anti-tips.
b. Pull anti-tip straight back to remove anti-tip from receiver.
c. To reinstall, press buttons in and push anti-tips back into receivers, aligning holes in receiver
with front detent button.
3. Setting for Seat Height
a. Using a 4mm Allen wrench and a 10mm wrench, remove cross bolt (Fig. 48:D) from height
adjuster (Fig. 48:E).
b. Slide height adjuster up or down as necessary, aligning holes in adjuster with hole in anti-tip.
The distance between the bottom of the anti-tip wheel and the floor should be between 1.5"
and 2".
c. Reinstall cross bolt through height adjuster and tighten.
d. Repeat for opposite side of chair. Ensure anti-tips on both sides of chair are set up identi-
cally.
Fig. 48
A
B
C
E
D