11
Engine Oil / Washer Fluid / Selective Catalytic Reduction
Checking the engine oil level [8]
Pull the dipstick out and check
the level. The level should be
between F and L.
Refilling engine oil [8]
Use only the specified engine oil
[9] and avoid spillage.
Checking the washer fluid
level [8]
Note: 1.6 CRDi derivatives of the CEED require a urea solution (also known as DEF (Diesel Exhaust Fluid))
for emission control that is added to a separate tank. The filler for the urea tank is located behind the
fuel flap next to the diesel fuel filler.
If the Urea level is not regularly checked and topped up this may cause the vehicle not to start.
Urea solution level gauge* [8]
Low urea solution warning
message* [8]
When “Refill Urea tank or
vehicle will not start” message
is displayed with SCR warning
lamp ( ), the vehicle can’t be
restarted once the engine is
turned off. For the above cases,
full replenishment is always
recommended.
Adding the urea solution* [8]
Idle Stop & Go (ISG)
When enabled, ISG
automatically stops the
car’s engine to reduce fuel
consumption and emissions.
The ISG function may not
work if the car’s battery
charge status, ambient
temperature and/or engine
temperature is too low. Air
conditioning/heater control
settings may also affect ISG
function.
Parking brake (handbrake)
When engaging the parking
brake, apply the footbrake
first and keep it depressed.
Then apply the parking
brake.
We strongly recommend
to leave the car in first or
reverse gear or in the ‘P’
(Park) position on automatics
when leaving the car.
Bluetooth
®
Many of our cars have
Bluetooth
®
connectivity to
enable the driver to safely
enjoy the convenience of the
mobile phone. For Bluetooth
®
compatibility please visit
the owners section on our
website.
Additional Info*
To Next Page
Loading...
