Driving your vehicle
245
Eco-Coasting operation condi-
tions
The Eco-Coasting system is activat-
ed when the accelerator pedal is
depressed and released under the
following conditions.
• When the driving mode is ECO
mode.
• When driver acceleration is
SMART ECO in SMART mode.
• When the shift lever is in the D
(Drive) position.
• When Cruise Control/Smart Cruise
Control button is OFF.
• The accelerator or brake pedal is
not depressed.
• When the vehicle speed is within
the range of 55 km/h to 160 km/h.
• If the road gradient is within the
range of -5% to +5%.
• In SMART mode, if the distance
between the vehicle ahead and the
relative speed is within a certain
range (if the Smart Cruise system
is equipped)
❈If the front radar for smart cruise
system cannot operate normally,
the inter-vehicle distance and rela-
tive speed condition are automati-
cally ignored.
❈The Eco-Coasting system works
after the engine is turned on, the
transmission is warmed up, and
the engine sensor self-diagnosis is
completed after starting.
❈Depending on the driving situation,
Eco-Coasting operation may be
temporarily delayed even if the
above conditions are met.
The Eco-Coasting system
release conditions
The Eco-Coasting system will be
automatically released when the fol-
lowing conditions are met.
• When the drive mode is COM-
FORT or SPORT mode.
• In SMART mode, when driver
acceleration is SMART COMFORT
or SMART SPORT.
• When using the paddle shift of the
steering wheel.
• When the Cruise Control/Smart
Cruise Control button is on (The
/
CRUISE indicator is on.).
• When pressing the accelerator
pedal or brake pedal.
• When the vehicle speed is outside
the rage of 55 km/h to 160 km/h.
• Road inclination is less than -5% or
exceeds +5%.
• In SMART mode, if the headway
distance to the vehicle ahead is too
close of the relative speed
changes momentarily (if the smart
cruise control system is equipped)
To Next Page
Loading...
Need help?
General
