Maintenance
1027
Inside light
1. Turn off the engine.
2. Open the tailgate.
3. Remove the service cover.
Back-up light/Tail light
4. Remove the socket from the assembly
by turning the socket counterclockwise
until the tabs on the socket align with
the slots on the assembly.
5. Remove the bulb from the socket by
pressing it in and rotating it counter-
clockwise until the tabs on the bulb
align with the slots in the socket. Pull
the bulb out of the socket.
6. Insert a new bulb by inserting it into
the socket and rotating it until it locks
into place.
7. Install the socket in the assembly by
aligning the tabs on the socket with the
slots in the assembly. Push the socket
into the assembly and turn the socket
clockwise.
8. Install the service cover by putting it
into the service hole.
Rear fog light (if equipped)
1.Remove the under cover by rotating
the screws.
2.Reach your hand into the back of the
rear bumper.
3.Disconnect the power connector.
4.Remove the bulb-socket from the
housing by turning the socket counter
clockwise until the tabs on the socket
align with the slots on the housing.
OUB071058
OUB071039
OUB071041R
OUB071053/H
To Next Page
