4
Connections
The KICKER Bullfrog has multiple hardware connections to
accommodate any audio application, indoors and outdoors.
Peel back the protective covering located on the side of the Bullfrog
to access the hardware panel. Remember to replace it when
fi nished. When operating near water or other risky areas, you are
solely responsible for maintaining the water-resistant integrity of the
Bullfrog. All connections should be removed and the cap should be
tightly secured.
Hardware reset
Line In - Provides audio input via 3.5mm connection
with AUX input mode.
External Antenna - Attach the included FM radio
antenna to increase the radio range. For best results,
place the antenna wire as high as possible.
USB Charge Bank - The USB Type A connection on the
Bullfrog acts as a power bank to charge your external
devices when the Bullfrog is on, or DC power is
connected. It is also used to update the fi rmware.
Charging current up to 2.1A.
DC Power - Power input using included wall-wart
power supply. Use only a KICKER-approved power
supply and the included power adapters.
To Next Page
Loading...
