Kidde 10LLDCO User Manual

12
7. Using Your Alarm (non-digital version, 10LLCO)
Tesng
Test your alarm each week by pressing the test buon. It will beep once followed by 4 loud
pulses, then a brief pause and then 4 more pulses, ending with a single beep. During this test
sequence, the red LED will flash for 10 seconds.
This confirms that the alarm is powered up and working.
Re-seng the Alarm
If the alarm sounds, the test / reset buon will silence the alarm unless it is sll detecng
dangerous levels of CO. The green light will then flash every 30 seconds to indicate that the
alarm has power.
Alarm Memory (non-digital only)
The red LED will flash every 60 seconds to indicate if a CO event has occurred whilst the house has been
unoccupied. This automacally cancels aer 14 days or if the reset buon is pressed.
11
2539-7201-05_10LLCO_10LLDCO_V1:_ 2016.11.2 9:06 AM Page 12

Kidde 10LLDCO Specifications

General

Brand	Kidde
Model	10LLDCO
Category	Security System
Language	English