Kidde 10SCO User Manual

This alarm also has a battery carrier tamper resist feature,
which helps prevent the battery carrier from being opened.
This feature is effective in preventing the removal of the
battery from this device.
To activate the battery carrier tamper resist feature, remove
the unit from the trim and locate the small cut-out in the
middle of the product label on
the back of the unit. With a
small screwdriver, or similar tool,
slide the switch towards the top
of the label. (see Figure 6) The
tamper resist feature is now
active and the battery carrier can
not be opened until the tamper
resist feature is deactivated.
FIGURE 6
Operating Instructions
POSTS
FIGURE 5A
FIGURE 5B
14
2540-7205-02_10SCO(KN-COPE-D).qxd:_ 2014.3.21 10:48 AM Page 19

Kidde 10SCO Specifications

General

Model	10SCO
Type	Smoke and Carbon Monoxide Alarm
Test/Reset Button	Yes
Silence Feature	Yes
Alarm Sound	85 dB at 10 feet
Interconnectability	No
Sensor Type	Electrochemical
Alarm Type	Smoke and Carbon Monoxide
Technology	Electrochemical
LED Indicator	Yes
Weight	0.6 pounds
Compliance	UL 217, UL 2034