18
REINSTALL IMMEDIATELY AFTER CLEANING AND THEN TEST
USING THE TEST/RESET BUTTON! IF TAMPER RESIST
FEATURE HAS BEEN ACTIVATED, REFER TO TAMPER RESIST
FEATURE DESCRIPTION ON PAGE 14 FOR REMOVAL
INSTRUCTIONS.
• Never use detergent or other solvents to clean the unit.
• Avoid spraying air freshener, hair spray, or other aerosols
near the Smoke/CO Alarm.
Do not paint the unit. Paint will seal the vents and interfere
with the sensor’s ability to detect smoke and CO. Never
attempt to disassemble the unit or clean inside. This action
will void your warranty. Move the Smoke/CO Alarm and
place in another location prior to performing any of the
following:
• Staining or stripping wood floors or furniture
• Painting
• Wall papering
• Using adhesives
Storing the unit in a plastic bag during any of the above
projects will protect the sensors from damage. Do not
place near a nappy bin.
WARNING: Reinstall the Smoke/CO Alarm as soon as
possible to assure continuous protection.
When household cleaning supplies or similar contaminates
are used, the area must be well ventilated. The following
substances can effect the CO sensor and may cause false
readings and damage to the sensor: Methane, propane,
iso-butane, iso-propanol, ethyl acetate, hydrogen sulfide,
sulfide dioxides, alcohol based products, paints, thinner,
solvents, adhesives, hair spray, after shave, perfume, and
some cleaning agents.fety
General Maintenance
To Next Page
Loading...
Need help?
General
