12
6. Using Your Alarm (non-digital version, 7CO)
Tesng
Test your alarm each week by pressing the test buon. The alarm will beep once followed by
4 loud pulses, then a brief pause and then 4 more pulses, ending with a single beep. While in
full alarm, the red LED will flash for 10 seconds.
This confirms that the alarm is powered up and working.
Re-seng the Alarm
If the alarm sounds, the test / reset buon will silence the alarm unless it is sll detecng dan-
gerous levels of CO. The green light will then flash every 30 seconds to indicate that the alarm
has power.
To Next Page
Loading...
