Kidde 7DCO User Manual

12
6. Using Your Alarm (non-digital version, 7CO)
Tesng
Test your alarm each week by pressing the test buon. The alarm will beep once followed by
4 loud pulses, then a brief pause and then 4 more pulses, ending with a single beep. While in
full alarm, the red LED will flash for 10 seconds.
This confirms that the alarm is powered up and working.
Re-seng the Alarm
If the alarm sounds, the test / reset buon will silence the alarm unless it is sll detecng dan-
gerous levels of CO. The green light will then flash every 30 seconds to indicate that the alarm
has power.
2530-7202-06_7CO(Caravans):_ 2015.2.9 10:18 AM Page 12

Kidde 7DCO Specifications

General

Type	Carbon Monoxide Alarm
Power Source	Battery
Battery Type	2 AA batteries
Display	Digital Display
Alarm	85 dB at 10 feet
Test/Reset Button	Yes
Sensor Type	Electrochemical
Operating Temperature	40°F to 100°F (4.4°C to 37.8°C)
Features	peak level memory
Operating Humidity	10% to 95% relative humidity (non-condensing)
Certifications	UL 2034