Kidde 7DCO User Manual

7
3. Switching on Your CO Alarm
NOTE: Your CO alarm must be installed by a competent person using the guidance that follows:
1. Remove the baeries from the pack and insert them into the baery compartment. Make
sure that you fit the baeries correctly to the polarity markings (+ or -) shown within the
baery compartment. If correctly installed, the alarm will give a short beep.
2. To test the alarm, press the test buon. The alarm will beep once followed by 4 loud
pulses, then a brief pause and then 4 more pulses, ending with a single beep.
3. If you have a digital read-out alarm (model 7DCO) the LCD screen will show “---“ and then
“888” before seling at “0”
4. Check that the green LED flashes at 30 second intervals to show that the alarm has power.
This is easiest to see in a dark area, or with lights switched off.
2530-7202-06_7CO(Caravans):_ 2015.2.9 10:18 AM Page 7

Kidde 7DCO Specifications

General

Type	Carbon Monoxide Alarm
Power Source	Battery
Battery Type	2 AA batteries
Display	Digital Display
Alarm	85 dB at 10 feet
Test/Reset Button	Yes
Sensor Type	Electrochemical
Operating Temperature	40°F to 100°F (4.4°C to 37.8°C)
Features	peak level memory
Operating Humidity	10% to 95% relative humidity (non-condensing)
Certifications	UL 2034