Kidde 900-CUDR-V - Other Alarm Visual And Audible Indicators

6
3. Other Alarm Visual And Audible Indicators
Operational Mode Visual Indications Audible Indications Action/Note
Normal (standby) Green LED blinks approx every
60 sec.
Test (button press when
no alarm condition is
present)
(Note: Test is very loud,
stand a few feet away.)
Red LED blinks in time with
alarm pattern.
• Single beep.
• 3 long beeps, voice “Fire!,”
3 long beeps, 4 quick beeps,
voice “Warning, Carbon Monoxide,”
4 quick beeps.
Perform button press once a week to
verify proper alarm operation.
Smoke or CO Alarm
Memory (unit has
experienced a smoke or
CO alarm event, or has
detected 100ppm CO or
greater.)
Smoke: Red LED blinks
every 15 sec.
CO: 2 red LED blinks
every 15 sec.
After button push, voice ““Caution,
carbon monoxide previously
detected.”
(If CO was detected. No voice for
smoke alarm memory)
NOTE: Alarm memory is only retained
for 24 hrs.
Push button to clear Alarm Memory.
Smoke Alarm Hush
TM
Mode
Red LED blinks every 2 sec. After button push, voice “Hush
Mode Activated.” Smoke alarm
pattern stops. (If there is too much
smoke to allow Hush
TM
, smoke alarm
pattern continues.)
Voice “Hush mode cancelled”
if button pushed again during
Hush
TM
.
This feature is to be used only when
a known alarm condition, such as
smoke from cooking, activates the
alarm.
Push button during Hush
TM
to clear
Hush
TM
and perform a test.
CO Alarm Reset None. After button push: CO alarm pattern
stops.
Unit is conrming if CO is present or
if it experienced a nuisance situation.
Re-alarm means danger. Move to fresh
air and call 911.