22
Mounting the Alarm
1. Choose a mounting location (wall or ceiling) and mark the
location with a pencil.
2. To ensure aesthetic alignment of the alarm with the hallway or
wall, the “A” line on the attachment stud should be parallel
with the hallway when ceiling mounting, or vertical when wall
mounting. See Figures 1 and 2.
3. Drill a hole through the pencil mark and use the enclosed screw
and anchor (see Figure 1) to secure the attachment stud. Use
1/4" (0.25") drill bit for anchor holes. Align the smoke/CO alarm
with the attachment stud and rotate clockwise (right) until the
unit is aligned. Screw and anchor accessories are supplied.
Figure 1 Figure 2
To Next Page
