Kidde VM-1 Technical Reference Manual

Chapter 7: Service and troubleshooting
136 P/N 3101890-EN • REV 006 • ISS 21JUN18
Address
Label Source Functional description
0017
Service Group Active CPU The system changes to the active state when an
operator enables a Service group from the LCD
command menu
0018
Two Stage Timer Active CPU The system changes to the active state when a
panel’s two-stage alarm timer starts
0019
Loop Controller Reset
Extension
CPU The system changes
to the active state when a loop
controller stays in the reset mode longer than
expected
0020
Service Device
Supervision
CPU The system changes to the active state when an
operator cancels a Service group test while a circuit
under test remained active
0021
User Trouble CPU The system changes to the active state when an
operator forces a trouble into the system (not
implemented at this time)
0022
Ext Database
Incompatibility
CPU The system changes to the active state when a
different database is in one or more network nodes
0023
Reboot Fault CPU The system changes to the active state when the
CPU module is interrupted unexpectedly
0101
–0164 Comm Fail xx CPU The system changes to the active state when the
CPU is unable to communicate with the networked
CPU module in cabinet xx
0200
–0222 Task xx Watchdog
Violation
CPU The system changes to the active state when
legacy
CPU task xx fails to execute properly
0261
–0279 Configuration Mismatch
Card xx
CPU The system changes to the active state when the
card in slot xx cannot perform the programmed
advance feature (currently only when in degraded
mode)
0281
–0299 DB Out Of Sync with CPU
Card xx
CPU The system changes to the active state when the
loop controller in the CPU rail slot xx reports an
actual and expected data mismatch
0300
-0399 Task xx Watchdog
Violation
CPU The system changes to the active state when VM-1
CPU task xx fails to execute properly
Table 51: Local alarm pseudo points
Address
Label Source Description
0676
Unprogrammed Device
DataCard 1
SLC A device that is not defined in the VM-CU database
is in alarm or trouble state
0686
Unprogrammed Device
DataCard2
SLC A device that is not defined in the VM-CU database
is in alarm or trouble state

Kidde VM-1 Specifications

General

Brand	Kidde
Model	VM-1
Category	Fire Alarms
Language	English