EasyManuals Logo

Kidde VM-1 Technical Reference Manual

Kidde VM-1
224 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #146 background imageLoading...
Page #146 background image
Chapter 7: Service and troubleshooting
138 P/N 3101890-EN • REV 006 • ISS 21JUN18
Address
Label Source Description
0608
Auxiliary Port Two CPU A short or open is detected on the port 2 serial
communication circuit
0608
Data Card Fault Two SLC The VM-SLC card on the loop controller is
missing or loose
0608
Waiting for SDU Download EAEC The database download from the VM-CU is in
progress or incomplete
0609
Panel in Download Mode CPU The panel is out of service to accept download
data
0609
Configuration Fault General A module is in the wrong slot
0610
Network Audio Circuit A Fault CPU There is a loss of signal on the primary audio
connection
0610
Rail Voltage Out of Spec PS10-4B The rail voltage is >30 VDC or <21 VDC
There is an excessive rail current load
The rail is faulty or misadjusted
0610
Telephone Line 1 DACT A line-cut fault is detected on phone line 1
0611
Network Audio Circuit B Fault CPU There is a loss of signal on the secondary audio
connection
0611
Telephone Line 2 DACT A line-cut fault is detected on phone line 2
0612
Receiver Test Line 1 DACT The line 1 test transmission to the CMS failed
0612
Unexpected Card CPU An undefined card is detected
0613
Low Battery Cut Off PS10-4B The battery voltage is below 19.5 VDC when on
battery backup
0613
Receiver Test Line 2 DACT The line 2 test transmission to the CMS failed
0614
AC Brownout PS10-4B AC line voltage is below 93 VAC at 50/60 Hz
0614
RS-232 Channel DACT There is a communication failure with the RS-
232
card on the module
0615
Battery Trouble PS10-4B There is an open on the wiring
The battery voltage is below 20.4 VDC
The battery internal resistance is too high
(load test failure)
0616
Network Class A Circuit A
Failure
CPU The CPU is unable to receive data on data riser
circuit A
0617
Network Class A Circuit B
Failure
CPU The CPU is unable to receive data on data riser
circuit B
0617
DSP Supervision DACT The DSP chip on the module failed
0617
Power Supply Failure PS10-4B The cables between the power supply and
CPU are loose or missing
The power supply is defective
0619
Charger Over Current PS10-4B The cables between the power supply and
CPU are loose or missing
The power supply or CPU is defective

Other manuals for Kidde VM-1

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Kidde VM-1 and is the answer not in the manual?

Kidde VM-1 Specifications

General IconGeneral
BrandKidde
ModelVM-1
CategoryFire Alarms
LanguageEnglish

Related product manuals