Chapter 3: Operating instructions
58 P/N 3101890-EN • REV 006 • ISS 21JUN18
To change the LED output state:
1. Access the Main Menu, and then select Activate.
2. Select LED, and then select the desired indication rate.
3. Select the desired output priority.
4. Enter the panel, card, and device address of the relay.
5. Enter the access level password.
To restore the LED output state:
1. Access the Main Menu, and then select Restore.
2. Select LED, and then select the desired indication rate.
3. Select the desired output priority.
4. Enter the panel, card, and device address of the relay.
5. Enter the access level password.
To Next Page
Loading...
