KIDDY Evostar 1 - 7 Using the Evostar 1 in Tandem Mode; Fitting the Tandem Adapters; Removing the Tandem Adapters

EN
16
Kiddy Maxi-Cosi Cybex Be safe Recaro
Evoluna i-Size Pebble plus Aton Q Izi go Privia
Evolunax Cabrio x Cloud Q
Evolution Pro 2
WARNING
Do not use any car seat unless specically recom-
mended by Kiddy.
For car seats used in conjunction with a chassis, this vehicle does not
replace a cot or a bed. Should your child need to sleep, then it should
be placed in a suitable pram body, cot or bed.
7. Using the Evostar 1 in tandem mode
7.1 Fitting the tandem adapters
Insert the tandem adapters (g. 33) onto the left and right sides of
the main chassis housings until it locks into place with a click (g. 34).
Ensure the locating hook is aligned with the locating pin on the rear
lower leg.
WARNING
Ensure the adapters are engaged before use by
pulling them upwards.
7.2 Removing the tandem adapters
Depress the grey buttons (g. 35, no. 1), un-hook the lower section
from the rear leg and remove from the chassis (g. 35, no. 2).