The maximum lie-at position is reached when the seat (E)
cannot be pulled any further forward.
The maximum angle of the lie-flat position depends on the position of the Isofix
anchorage points in the vehicle.
5 Seat location selection and adjustment
5.1 Adjustment of the vehicle seat
Read all the necessary information about the use of child
restraint systems (A) in your vehicle owner’s manual.
If installation is impeded by a head support, it must be used in the top-most
position or removed (Fig. 10).
With the moving back rest (B) of the kiddy phoenixfix 3, it can be assured that
it rests against vehicle seat back rest. Position the adjustable back rest of the
vehicle seat appropriately.
5.2 Seat location for universal installation
The kiddy phoenixfix 3 child restraint system (A) can be installed on any seat of
vehicles equipped with a 3-point vehicle seat belt system (Fig. 11).
The kiddy phoenixfix 3 can also be used on rear-facing vehicle seats which are
equipped with a 3-point vehicle seat belt system (Fig. 11).
* If the vehicle manufacturer permits child restraint systems on the front pas-
senger seat, the seat should be moved to the rear-most position.
When you install the kiddy phoenixx 3 in universal mode
(without k-x
+
), the connectors (D) must be retracted. See
Point 8 for this.
To Next Page
Loading...
