37
ATTACHMENT OF SAFETY SEAT FOR GROUP 0, 1
11
REARWARD TO THE DIRECTION IN WHICH THE VEHICLE IS MOVING –
3-POINT SEAT BELT
C. Remove the reduction cushion and pull the hip belt along the front of the safety
seat. Pull the shoulder belt through the belt guide for Group 0 – rearward facing
(Product Components Overview, element 13).
REMEMBER: always use the shoulder belt guide on the opposite side of the car seat
belt buckle - see illustration.
A. Rotate the safety seat rearward to the direction in which the vehicle is moving. For
Group 0, adjust the inclination to Position 4. Attach the ISOFIX Attachment and
connect them to the vehicle seat with the use of the ISOFIX Guide Sleeves. More
information can be found in Chapter 8: ISOFIX ATTACHMENT.
REMEMBER: Grab the entire safety seat fi rmly and make sure that it is properly
attached.
B. Connect Top Tether to the vehicle anchor and wrap it around the safety seat in
a way shown in the picture above. More information can be found in Chapter 9: TOP
TETHER SYSTEM. Top Tether adjustment buckle should be pointing downwards
when connecting with the vehicle anchor. While extending Top Tether, pay attention
to the buckle on which there is an attachment indicator. Top Tether should be
extended until the green indicator appears.
REMEMBER: Grab the entire safety seat fi rmly, make sure that it is properly attached
and make sure that all safety systems function correctly.
Shoulder belt
Lap belt
To Next Page
Loading...