Kikkoman Biochemifa Smart - Specification of a Blank Tube (Negative Rod)

14
11. Specification of a light source (positive rod)
Item
Contents
Light emitting device
Green LED
Center wavelength
Typ.545nm
Half width of spectrum
40nm (Typ.)
RLU value
It is displayed on the label of a light source.
Ambient temperature range
+10 - +30°C
Ambient humidity range
20 - 85% (Free from condensation)
Storage temperature range
0 - +35°C
Storage humidity range
20 - 95% (Free from condensation)
Internal power source
Electric double layer capacitor
Terminal for charge
Outer diameter: Φ5.5mm Inner diameter: Φ2.1mm
(Center plus)
Input voltage 5.0V
Charging current
MAX 1A
After the completion of charge: About 2 mA
Charge time
30 seconds or more
Operating time
15-minute after the completion of charge
Dimensions
Diameter: Φ12mm Length: 134.7mm
Weight
About 20 g (except AC/DC adaptor)
12. Specification of a blank tube (negative rod)
Item
Contents
RLU value Typ. 0RLU
Tolerance of a RLU value
Minimum 0RLU. Maximum 10RLU
Dimensions
Diameter: about Φ12mm Length: about 149.5mm
Weight
About 10g
13. Calibration
This device is factory-calibrated, with a minimum period of validity as stated on the
label. The calibration will only be valid if the instructions contained in this document
are followed. Any non-recommended use may compromise this calibration.
Following the stated period of validity, the device can be re-calibrated and re-labeled
with new period of validity for a fee.