Kikkoman Biochemifa Smart - Page 7

5
Other cautions
When you use this equipment, be careful of the following things.
• This equipment is Lumitester Smart/PD-30/PD-20 exclusive use. Do not insert a
light source or blank tube in Lumitester PD-
10. Or do not insert to other company
products.
• Do not move this equipment during measurement. It may
cause an error of
measurement.
• Do not incline this
equipment during measurement. It may cause a measured
value error.
• Be sure to take out a light source after measurement.
• Keep this equipment at least 50cm away from the electromagnetic noise source.
• Do not expose this equipment to liquids, reagents, and organic solvents. That may
cause failure, discoloration and modification. If they are attached, wipe off immediately.
• Use it in the range of temperature (10-30
ºC) and humidity (20-85%).
*In case of Lumitester Smart/PD-
30, turn off the temperature compensation
setting.
• Do not use it at the place where temperature changes violently.
• Do not use it at a place with sunlight or strong light. It may cause
an error of
measurement.
• Do not expose it to steam. Use it at the place without dewing.
• Do not expose it to corrosive gas.
• Use it at a place without vibration.
• Use it at a place with little dust.
• Do not put on unstable place or a dangerous place.
• Do not fall it or give a strong shock.
• Avoid the place where the wind of an air-conditioner hits directly.