6-4Names and Functions of Controls PASSERIES
[8] VOLTAGE/PWR DSPL
Selects the digit when setting the voltage. The digit changes for each
click.
Pressing the VOLTAGE switch while pressing the SHIFT switch dis-
plays the output power on the voltage display. See "3.4 Switching the
Power Display".
[9] CURRENT/
PWR DSPL
Selects the digit when setting the current. The digit changes for each
click.
Pressing the CURRENT switch while pressing the SHIFT switch dis-
plays the output power on the current display. See "3.4 Switching the
Power Display".
[10] SET
Switch used to set or check the output v
olt
age value or output current
value. When the switch is illuminated, the value can be entered. The
value is indicated on the display.
When the switch is not illuminated, the display section shows the
measured values of the voltage and current of the output terminals.
[11] OVP/
OCP
Pressing this switch displays the OVP (overvoltage protection) trip
voltage on the display section.
For details on how to set the OVP trip point, see "3.2.2 Setting the
OVP (Overvoltage Protection) Trip Point".
Pressing the OVP switch while pressing the SHIFT switch illumi-
nates the switch and displays the OCP (overvoltage protection) trip
current on the display section.
For details on how to set the OCP trip point, see "3.2.3 Setting the
OCP (Overcurrent Protection) Trip Point".
[12] Dial
Turn the dial (clockwise or counterclo
ck
wise) to set the voltage or
current, CONFIG settings, and node address.
You can also press when set the voltage or current, the dial to change
the digit.
To Next Page
Loading...
