Kimball Office Footprint Xsite User Manual

Systems Assembly Instructions
Footprint
®
Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call Kimball Office Customer Care.
Part No. 1741505 Revision A-04
Page 1 of 3
Lunar Overhead Storage
Cabinet Ganging Bracket
for Xsite
®
/Traxx
®
Tools Required
■ Electric Drill/Driver ■ Rubber (non-marring) Mallet
■ #3 Phillips Head Bits
Package Contents
■ 1 Ganging Bracket ■ 2 #10 x ¹⁄₂" Self-drilling
Phillips Panhead Screws
Installation
Note: This instruction covers installation of ganging brackets
for all Lunar cabinetry assembled and installed on Xsite and
Traxx only. All operations to assemble the cabinet and doors
can be done by one person, but it is recommended that two
people install the units to the panel system/Traxx.
Important: This instruction explains basic Lunar ganging
bracket assembly techniques. Please see assembly instruction
“Lunar Overhead Storage, Flipper Door Cabinet” for basic
cabinetry assembly and installation to panel systems as
needed.
Purposes of the ganging bracket:
■ To align the front lower edge of the adjacent cabinet.
■ To add rigidity to the installed cabinets.
Figure A
Figure B
Pre-installation action: As mentioned above, reference
assembly instruction “Lunar Overhead Storage, Flipper Door
Cabinet” to assemble all cabinetry and install it to Xsite panels
and/or Traxx. Take care to not damage the unit(s) or the
panel. Inventory the package contents before proceeding with
assembly/installation. Stop if there are insufficient items to
complete the assembly.
1. Figure A shows a single door Lunar overhead cabinet for
reference.
2. Figure B shows a typical side-by-side application for
ganging on an Xsite panel run.

Kimball Office Footprint Xsite Specifications

General

Category	Indoor Furnishing
Manufacturer	Kimball Office
Product Name	Footprint Xsite
Type	Office Furniture
Product Type	Workstation
Series	Footprint
Material	Laminate, Metal
Adjustability	Yes
Warranty	Limited Lifetime Warranty
Color Options	Multiple options available

Summary

Pre-installation Actions for Ganging Bracket

Reference Previous Assembly Instructions

Assemble cabinetry and install to Xsite panels/Traxx before proceeding with the ganging bracket.

Inventory Package Contents

Verify all package contents are present before starting assembly/installation.

Lunar Cabinet Ganging Bracket Installation

Tools and Package Contents Overview

Lists required tools like drill and mallet, and package contents including brackets and screws.

Ganging Bracket Purpose

To align front lower edges and add rigidity to adjacent installed cabinets.

Cabinet Positioning

Position cabinets for direct contact with no gaps, lifting front edges to slide.

Ganging Bracket Placement

Loosely position bracket under lower front flanges, ensuring vertical 'ears' are behind shelf flange.

Seating the Ganging Bracket

Press bracket upward to fully seat; a mallet may be needed for the 'ears' to grip interior panels.

Securing the Ganging Bracket

Install self-drilling screws into bracket's lower flange, angling outward for best grip.

Final Alignment Check

Lower cabinets, re-check front lower edges for alignment and direct contact.

Door and Lock Operation Check

Close cabinet doors and re-check all door and lock operations.