Footprint
®
1
Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call Kimball Office Customer Care.
2498904 Revision -
Assembly Instructions
Modular Casegoods– Desks
Tools Required
Hardware Provided
Drill with 1/8” and #2 Phillips tip bits
5/16” Hex socket
Level
Measuring tape
Flat head screwdriver
To reduce installation time, it is recommended you install
modular casegoods in the following order:
1. Pedestal
2. End Panel
3. Modesty Panel
4. Undersurface Lateral File or File Center
Installation Planning
Metal to Worksurface: #10 Phillips pan head particle
board screws.
Metal to Metal: #10 x 1/2” hex washer head drill screws
Figure A
Figure B
Figure C
Four Spacers are included with all Pedestals and Under-
surface Lateral Files. These ARE NOT used unless
freestanding unit is part of systems installation, e.g. a
freestanding return joined to a systems top.
General Information
To remove Pedestal Box and Undersurface Lateral File
drawers (Figure B):
1. Begin with top drawer (Figure C). Extend drawer fully.
2. Insert flat head screwdriver in between pedestal drawer
and slide. Pry slide away from drawer slightly (Figure C).
3. Put one hand underneath drawer. Lift front of drawer up to
disengage from front drawer slide channel hooks.
4. When front of drawer is disengaged, pull entire drawer
towards you, supporting it from the bottom. This should
disengage drawer from rear drawer slide channel hooks.
5. Set all drawers aside and slide drawer channels back into
case. Do not try to remove the entire drawer slide.
Removing Drawers
To Next Page
Need help?
General