Kimball Office Fundamental User Manual

Fundamental
®
1
Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call Kimball Office Customer Care.
2242718, Revision D
Assembly Instructions
Installing Filing Counterweight
Tools Required
Hardware Required
 Flat Head Screwdriver
 5/16” Hex Socket Nut Driver
 Phillips Head Screwdriver
1. Fully extend drawer. (Fig B)
2. While gripping and lifting near the top edge of the drawer
side, hand strike the drawer side just above the extended
slide to release the front locking tab. (Figure C).
3. Repeat this procedure at the rear of the drawer side.
4. Support the released end of the drawer with one hand
placed underneath the drawer center.
5. Strike the opposite drawer side to release each of the lock-
ing tabs.
6. Lift drawer from the slides.
Installation
 #8 X 3/8” Phillips Head Sheet Metal Screw. (Qty: 4)
 #10 x 1/2” Self Drilling Hex Head Sheet Metal Screw.
(Qty: 2)
 Counterweight Enclosed in Cardboard Box. (Qty: 1)
NOTE: Do not remove counterweigh from card-
board box. (Figure A).
Figure A
Figure B Figure C
Counterweight
Brackets
Rear Locking Tab
Front Locking Tab

Kimball Office Fundamental Specifications

General

Brand	Kimball Office
Model	Fundamental
Category	Indoor Furnishing
Language	English

Summary

Installing Filing Counterweight

Tools Required

Lists the necessary tools for installing the counterweight, including screwdrivers.

Hardware Required

Lists the required screws and counterweight components for the installation process.

Drawer Removal Procedure

Details the steps for safely removing the drawer from the filing cabinet slides.

Counterweight Installation

Describes how to attach the counterweight using brackets and screws to the filing cabinet.

Drawer Reinstallation

Explains the procedure for reinserting the drawer back into the cabinet slides.