GP 500 0-10 000 Pa :
Measuring range From -10 000 to +10 000 Pa
Accuracy* in measuring ±0.15 % of the reading +6 Pa
Generation range From -10 000 to -50 Pa and from +50 P to +10 000 Pa
Accuracy* in generation From -10 000 to -1000 Pa : 10 Pa
From -1000 to +1000 Pa : 1 Pa
From +1000 to +10 000 Pa : 10 Pa
Resolution From -10 000 to -1000 Pa : 1 Pa
From -1000 to -100 Pa : 0.1 Pa
From -100 to +100 Pa : 0.01 Pa
From+100 to +1000 Pa : 0.1 Pa
From +1000 to +10 000 Pa : 1 Pa
Autozero Automatic
Manual (keypad)
Units
Pa, daPa, hPa, mmH
2
O, mmHg, mbar, inWg
*All the accuracies indicated in this technical datasheet were stated in laboratory conditions, and can be guaranteed for measurements carried out in the same conditions, or carried out
with calibration compensation
1.3. Electrical connections
The electrical power supply of the GP500 must be equipped with a protection system against the leakage
currents adapted to the device power.
Any intervention or electrical connection must be carried out by a formed and qualified technician.
The device must be turned off.
Before connecting, check the type of power supply indicated on the product.
Introduction 7
To Next Page