FRET INFORMATION
To enable Customers to choose their own style of fret these fires are now available
without frets. In order to maintain the efficient and safe operation of the fire it is
important that any fret which is used must comply with the following dimensions.
(figure 41) It is important to clean a fret in accordance with the instructions
provided by your retailer as these vary depending on the surface finish of the fret.
Fig. 41
PARTS SHORTLIST
Replacement of parts must be carried out by a competent person such as a
registered gas installer. The part numbers of the replaceable parts are as follows,
these are available from your local stockist, whose details may be found on the
BFM Europe website, address as per rear page.
Complete coal / ceramic set B-105190
Fuelbed base B-105070
Fuelbed front rail B-126490
Replacement coal set B-105180
Glass panel B-125640
L/H fibre board (plain) B-58610
R/H fibre board (plain) B-58620
Upper rear fibre board (plain) B-58600
Lower rear fibre board (plain) B-58590
Piezo Igniter B-1320
Ignition wire manual models B-67910
Ignition wires slide models B-50380
Ignition wire remote models B-34690
NG manual gas valve B-102880
LPG manual gas valve B-102960
NG slide valve B-40980
NG RC gas control valve B-160780
RC handset B-168970
NG MC ODS pilot B-38930
NG SC ODS pilot B-49710
NG RC ODS pilot B-170240
LPG MC ODS pilot B-162300
50
Maximum
Height
210mm
Two Air Slots each of
Minimum Area 19cm2
Minimum Total Open
Area of Fret 110cm2
To Next Page
Loading...
