Kinesis Savant Elite2 Quick Start Guide

3
Jack 1
CUSTOM CONFIGURATION (WINDOWS)
1. With the SE2 device connected to a PC, activate Program Mode
by SLIDING THE SWITCH on the underside of the device. For
waterproof models, DEPRESS A PEDAL BRIEFLY WHILE PLUG-
GING IN THE USB. The red LED will illuminate briey.
2. Once the LED changes to ashing green, open the “KINESIS FP”
drive. If you do not see an AutoPlay popup, look in “My
Computer” for “KINESIS FP”.
3. Once inside the KINESIS FP drive, double-click the “SE2
SmartSet App (Win)” application to run it.
4. To program a new custom action, click CONFIGURE for the
desired jack.
5. Choose the type of action to program by clicking either “Single
Action”, “Multiple Actions (Macro)” or the “Special Actions”
drop-down menu.
6. INPUT desired action(s) into the yellow programming box and
click DONE.
7. The newly programmed action will now appear in the
corresponding gray box below. REPEAT steps 4—6 as
necessary to congure additional jacks.
8. If you are satised with your new custom action(s) click SAVE,
and then click EXIT PROGRAM.
9. Put the device back into Play Mode by sliding the switch. For
waterproof models, RE-PLUG THE USB.
10. Your Savant Elite2 device is now ready to use with your custom
programmed actions!

Kinesis Savant Elite2 Specifications

General

Brand	Kinesis
Model	Savant Elite2
Category	Music Pedal
Language	English