What to do if my King Canada KC-163SSC-V motor will not run?
If the motor of your King Canada Saw won't run, it might be due to a defective cord or plug, which should be replaced. Alternatively, the motor itself could be defective, or there might be defective wire connections. Note that any attempt to repair the motor may create a hazard unless the repair is done by a qualified service technician.
Why are my King Canada KC-163SSC-V blades breaking?
Breaking blades on your King Canada Saw can be caused by several factors. Ensure the blade tension is properly adjusted. Reduce the feed rate to avoid overworking the blade. Use the correct blade for the material thickness—narrow blades for thin wood and wide blades for thicker wood. Avoid applying side pressure to prevent twisting the blade. Finally, ensure the blade has a minimum of 3 teeth in contact with the workpiece to use correct teeth per inch.
How to reduce vibration in my King Canada Saw?
Vibration in your King Canada Saw can stem from a few causes. Start by ensuring the saw is properly mounted. The mounting surface should be heavy and stable—a plywood workbench may not be effective. Also, check that the table lock knob is tightened to prevent the table from resting against the motor.
What to do if blade runout on King Canada Saw?
If the blade runout occurs, meaning the blade is not in line with the arm motion on your King Canada Saw, it is likely that the blade holders are not aligned. To fix this, loosen the screws holding the blade to the upper and lower arms, and then adjust the position of the blade holders.
General| Brand | King Canada |
|---|---|
| Model | KC-163SSC-V |
| Category | Saw |
| Language | English |
To Next Page
