How to fix a King Canada KC-902C when the motor won't run?
If the motor of your King Canada Saw isn't running, there are a couple of potential causes. First, the on-off switch or power cord might be defective; in this case, you should replace the defective parts. Second, the motor itself might be defective. Any attempt to repair the motor yourself could be hazardous and should only be done by a qualified service technician.
Why are the blades breaking on my King Canada KC-902C?
Blades on your King Canada Saw might be breaking due to a couple of reasons. One possibility is that there's too much tension, so you should adjust the tension. Another reason could be a kink in the blade, caused by cutting too small a radius or turning the material too fast. In this case, you should use the correct cutting technique.
What to do if my King Canada KC-902C blade will not cut straight?
If your King Canada Saw blade won't cut straight, it could be due to a couple of reasons. The blade guides and back-up bearings might not be adjusted properly, so you should adjust the upper and lower blade guides and bearings. It could also be due to a worn or defective blade where the offset blade teeth may have been flattened, so you should replace the blade.
Why is my King Canada Saw so noisy when running?
If your King Canada Saw is making excessive noise while running, there are a couple of potential causes. It could be due to too much blade tension, in which case you should adjust the blade tension. Alternatively, the blade guides and back-up bearings might be in contact with the blade, so you should adjust the upper and lower blade guides and bearings.
Why does my King Canada Bandsaw slow down when cutting?
Your King Canada Bandsaw might be slowing down when cutting due to a couple of reasons. One reason could be that you're cutting too small a radius; in this case, stop feeding and back up the material slightly until the bandsaw speeds up. Another reason could be a dull blade, so you should replace the blade.
How do I fix a King Canada KC-902C Saw blade that doesn't run in the center of the upper wheel?
If the blade on your King Canada Saw isn't running in the approximate center of the upper wheel, it might not be tracking properly, so you should adjust the tracking.
Details the 2-year limited warranty against defects in materials and workmanship.
Details voltage, fuse, and circuit breaker requirements for safe operation.
Explains the importance and procedure for grounding the bandsaw.
Guidelines for selecting and using extension cords to prevent hazards.
Explains the safety key feature for preventing unauthorized use.
Step-by-step instructions for mounting the table onto the bandsaw.
How to attach the rip fence and miter gauge for cutting operations.
Guidance on securely mounting the bandsaw to a stable surface.
How to set the upper blade guide to the correct height above the workpiece.
Steps to tilt the table to a desired angle for bevel cuts.
Procedure to ensure the table is set at a 90° angle to the blade.
Instructions for safely replacing or installing a bandsaw blade.
How to properly tension the bandsaw blade for accurate cuts.
Procedure for aligning the blade to run correctly on the wheels.
How to set blade guides and back-up bearings for optimal performance.
Instructions for operating the work light and laser guide switches.
How to use the laser guide for ripping operations.
Steps to align the laser guide with the blade kerf.
How to connect and use the dust collection system.
General techniques for curve and straight line cutting.
General procedures for keeping the bandsaw in good working order.
Instructions for cleaning and replacing bandsaw tires.
How to maintain the table, guides, and bearings for optimal cutting.
Maintenance advice for the motor and electrical components.
Information regarding lubrication requirements for bearings.
General| Bevel Angle Range | 0° - 45° |
|---|---|
| Miter Gauge | Included |
| Motor Power | 15 Amp |
| Motor | 120 V |
| Blade Diameter | 10 inches |
| Arbor Size | 5/8 in |
To Next Page