King Industrial KC-788FX User Manual (English)

Other manuals for King Industrial KC-788FX

Questions and Answers:

S
sarahjacksonJul 29, 2025
What to do if my King Industrial Sander motor doesn’t start and the fuse is burnt?
- J
  Juan GarciaJul 30, 2025
  If your King Industrial Sander motor doesn't start and the fuse is burnt or the circuit breaker tripped, there might be a short circuit in the plug or switch. Check the plug or switch for bad insulation or contact. Also, examine all motor connections for shorts or bad wire insulation. Ensure you have the correct fuse or circuit breaker installed. Finally, the thermal overload may be tripped; press the thermal overload button to reactivate it.
H
hwelchAug 3, 2025
Why King Industrial KC-788FX motor does not develop maximum power?
- T
  Teresa ButlerAug 3, 2025
  If your King Industrial Sander's motor isn't developing maximum power, it could be due to several reasons. The power source might be overloaded with lamps, accessories, or another motor; try reducing the load on the circuit. The wiring might be too small or the circuit line too long; consider increasing the wire size or reducing the length of the circuit line. There could also be an electrical company overload, in which case you should request a voltage check by your power supplier. Lastly, the drive V-belt might be tensioned incorrectly; readjust the V-belt tension.
C
Cassandra BellAug 8, 2025
How to troubleshoot King Industrial KC-788FX motor that doesn’t start?
- J
  jeffreywhiteheadAug 8, 2025
  If your King Industrial Sander motor doesn’t start, it could be due to a voltage drop. Check the power source. There may also be a motor short circuit or bad connection. Check all motor connections. The thermal overload may have tripped; press the thermal overload button to reactivate it.
R
Raymond FigueroaAug 14, 2025
Why King Industrial KC-788FX Sander motor overheats?
- D
  Dominic LewisAug 14, 2025
  If the motor of your King Industrial Sander overheats, it could be due to a motor overload. Try reducing the load on the circuit. Alternatively, the drive V-belt might be overtensioned; retension the V-belt properly.
B
briana39Aug 18, 2025
What to do if King Industrial KC-788FX motor chokes?
- J
  Jonathan WeberAug 19, 2025
  If the motor of your King Industrial Sander chokes (caused by burnt fuse or tripped circuit breaker), it could be due to a short-circuited motor or bad connection. Check all motor connections or bad wire insulation. The voltage might be too low; rectify the voltage. It could also be due to an incompatible fuse or circuit breaker in the electrical box; install proper fuses or circuit breakers. Finally, the motor might be overloaded; reduce the charge on the circuit.