To Next PageTo Next Page
Need help?Do you have a question about the KING cable and is the answer not in the manual?
General| Type | Heating cable |
|---|---|
| Voltage | 230V |
| Application | Underfloor heating |
| Insulation Material | XLPE |
| Diameter | 5-7 mm (depending on model) |
| Power | 10-20 W/m (depending on model) |
Tests insulation jacket for damage using a multimeter to check for open or OL reading.
Measures cable resistance for continuity and wattage rating using a multimeter.
Measures floor sensor resistance to verify integrity using a multimeter.
Guide to selecting the correct voltage and cable size based on heated area and spacing.
Details on marking thermostat location, cold lead start, and sensor placement.
Instructions for determining junction box location and connecting wires.
Creating an opening in the wall for a remodel junction box.
Installing a remodel type electrical junction box for the thermostat.
Installing a nail plate to protect wires in a remodel installation.
Chiseling a groove in the floor for the cold lead splice to ensure embedment.
Securing the cold lead splice into the chiseled channel with hot glue.
Installing and connecting the cable monitor throughout the installation process.
Running the heating cable into end straps, creating a 180-degree turn with 1" bend radius.
Performing post-embedding tests to ensure no damage occurred during mortar application.
