KI 9000 UM-14
CARE OF YOUR INSTRUMENT
Follow the directions in this manual on optical connector care.
• Use only high quality sealed alkaline or NiMH or NiCad batteries.
• During prolonged storage, remove batteries to eliminate the
possibility of acid leakage.
• During storage and transport, keep the instrument in its carry case
to protect against crushing, vibration, dust and moisture.
• The instrument is resistant to normal dust and moisture, however
it is not waterproof. If moisture gets into the instrument, dry it out
carefully before using it again.
• Where possible, keep instrument away from direct sunlight.
• Clean the instrument case using alcohol or other none solvent
cleaning agents. Acetone or other active solvents may damage the
case.
• The instrument housing is made of tough polycarbonate material
with impact absorbing rubberised sides and corner features and is
therefore drop resistant.
• Carefully observe operational precautions for the type of fiber optic
connector interface fitted. Refer to previous section.
Power Meter
• Input optical power must not exceed the damage level specified
for each detector type.
To Next Page
Loading...
