TAMPERLOCK MODE
TAMPERLOCK
TamperLock Mode enables lower skill, repetitive and error-free
measurements, such as fixed wavelength or laser output power.
This is useful to, for example, pre-set an instrument for use by
unskilled personnel, or to just lock the instrument down for easy use
for one specific application.
This achieves the operational simplicity of very basic instruments, yet
allows the instrument to be re-configured as needed, so achieves both
objectives.
To set up this mode, configure the instrument, and enter a unique PIN
code. As long as this is maintained, the instrument is locked into this
mode.
It’s possible for a user to end / escape this mode (maybe they have
changed work sites etc.). To re-apply the mode requires adding
another PIN code.
After a job is complete, entering the known pin code will show a “pass”
if the instrument is still in TamperLock mode, or “fail” if it has been
escaped.
Power Meter
While in TamperLock Mode, user is prevented from changing
wavelength, dB/dBm/mW, Hold, min max and SlowMode settings.
See Power Meter Quick Reference Guide at the end of this manual for
TamperLock operations.
Light Source
While in TamperLock Mode, the user is prevented from changing
wavelength or laser output power.
See Light Source Quick Reference Guide at the end of this manual for
TamperLock operations.
To Next Page
Loading...
Need help?
General
