6.35mm(1/4 inch) Hex Shank.
HOW TO USE IT BY ELECTRIC?
You need to prepare:
Take out the handle and install
the black O-ring to the PC lid.
Ensure that the bit holder is fully inserted
into the center shaft, grasp the grinder
firmly, and gradually apply power.
PRECAUTIONS:
Electric screwdriver at a 15~25Nm torque.
Slow down the grinding speed to prevent damage to the central shaft.
The entire grinder should not be washed with water. Please use the
brush for cleaning.
1.
Do not rotate the handle when the grind setting is at 0 or below 15
clicks, as this could damage the burr set.
2.
For precision reasons, do not dismantle the exterior burr. Avoid
forcefully disassembling the grinder with tools.
3.
Only grind coffee beans. Do not grind unroasted coffee beans. 4.
Avoid spraying water directly onto any part of the grinder. You can
perform RDT by spraying water on another object.
5.
Avoid second grinding as the coffee fine powder may block the parts.6.
Please store in a dry environment.7.
To Previous Page
Loading...
