Issue: 04/2011
The xenon lamp automatically ignites when pushing the start button on the projector
operating panel.
You can manually ignite the xenon lamp by pushing the ignition button.
Do not push this button for more than 0.5 seconds. The xenon bulb can be damaged
if you push for a longer time. If the xenon lamp does not ignite after you have pushed
the button two to three times, the ignition unit or the rectier or the xenon bulb probably
have a defect.
By turning the hand wheel, the iron core in the coils will be moved and the intensity of
current will be changed. The adjusted intensity of currents can be read on the
ammeter.
X
Z If you have an electronic rectier the intensity of current is adjusted via a
potentiometer switch.
Z Detailed information about the rectier can be found in the corresponding operating
manual.
Z Values for the intensity of currents, see chapter 6.4.16.
To Next Page
Loading...
