(1) Drain Plug (1) Engine Oil Filter
5. Remove the oil filter behind the
cooling fan on the right side of the
engine.
6. Apply a thin lm of oil to the O-ring
of a new filter and tighten the
O-ring rmly by hand.
7. Add the engine oil to the specied
level and tighten the oil lter to the
specied torque.
2. Stop the engine, apply the parking
brake, and remove the drain plug.
3. To drain the used oil, remove the
drain plug at the bottom of the en-
gine and drain the oil completely
into the oil pan.
All the used oil can be drained out
easily when the engine is still warm.
4. Remove engine oil ller cap to al-
low easy draining of engine oil.
tb3O707A tb3O708A
7. Run the start motor for approx. 10
seconds to deliver oil to each part.
8. Run the engine for approx. 5 min-
utes and check if the oil warning
lamp comes on. If it does not come
on, stop the engine. (It is normal
that the oil warning lamp is off
while the engine running)
9. Check the engine oil level again
with the oil dipstick. If the level is
low, add more oil.
The engine oil filter should be
replaced when changing the en-
gine oil.
NOTE
Oil capacity (with lter)
1.0 U.S.gal. (3.8 L)
To Next Page
Loading...
Need help?
General
