swinging and shaking during trans-
port and work that could jeopardize
the stability of the tractorimplement
assembly.
• The cardan shaft must be always
CE-marked, provided with suit-
able guards and suitable to tractor-
implement coupling. Follow all
directions of the operation manual,
concerning both the fastening ac-
cording to connection direction and
safety rules to avoid rotation of
protections (chains) and overlaying
of the telescopic tubes. Also keep
articulation angles.
WARNING
When a tractor with safety
frame is equipped with a front
loader, there is still a risk if the
implement is improperly used.
This risk is due to objects fall-
ing from above. The operator
has no protection against this
risk.
•
To reduce risks, the following precau-
tions should be used.
- Only use loader equipped with a
load self-levelling system, i.e. of the
parallelogram type.
- Only use specific implements for
the operation to be performed.
Strictly follow the directions and
warnings in the loader's operation
manual.
- Use the machine and the imple-
ment with caution, drive on plane
ground and avoid pits, excavations
and ditches. Do not turn, start or
stop abruptly.
- If a front loader is mounted, it is
advisable to use a tractor with cab
or with a 4-post frame with FOPS
safety system. The loader installer
should carefully analyze all risks
and make all required adjustments.
• Hitch loads to the drawbar only.
Towing or attaching to other loca-
tions may cause the tractor to over-
turn.
• Improper use of the drawbar, even
if correctly positioned, can cause a
rear overturn.
• DO NOT overload an attachment
or towed equipment. Use proper
counterweights to maintain tractor
stability. Hitch heavy loads to the
drawbar only.
Tg2O111a
To Next Page
Loading...
Need help?
General
