OPERATING 5-23
WARNING
Do not use tires larger than speci-
fied.
Do not attempt to mount a tire.
This should be done by a quali-
fied person with the proper
equipment. Qualified persons
with the proper tire mounting
equipment should recognize the
following warning.
Never exceed 241 kPa (35 psi)
when attempting to seat a bead. If
beads have not been seated by the
time the pressure reaches 241 kPa
(35 psi), deflate the assembly, re-
position the tire on the rim, redu-
plicate and reinflate. After seat-
ing the bead, adjust inflation pres-
sure as recommended in the in-
flation pressure chart.
A12O529A
TIRES
Though the tire pressure is factory-set
to the prescribed level, it naturally drops
slowly in the course of time. Thus, check
it everyday and inflate as necessary.
(A) Insuffient (B) Standard
(C) Excessive
INFLATION PRESSURE
Though the tire pressure is factory-set
to the prescribed level, it naturally drops
slowly in the course of time. Thus, check
it everyday and inflate as necessary.
NOTE
Maintain the maximum pressure in
front tires, if using a front loader or
when equipped with a full load of front
weights.
Classi-
fication
Front
Rear
Front
Rear
Front
Rear
Tire Size
9.5x16PR
13.6x26PR
9.5x18PR
13.6x28PR
9.5x20PR
14.9x28PR
Inflation
Pressure
205 kPa
(2.1kgf/cm²,30psi)
150 kPa
(1.5kgf/cm²,22psi)
205 kPa
(2.1kgf/cm²,30psi)
150 kPa
(1.5kgf/cm²,22psi)
205 kPa
(2.1kgf/cm²,30psi)
140 kPa
(1.4kgf/cm²,20psi)
DK451
DK501
DK551
TIRES, WHEELS AND BALLAST
To Next Page
Loading...
