29
NOTE
If you have to replace one or both rear wheels or tyres,
make sure that any differences in their external diameter does not exceed
8-10 mm. Change in wheel/tyre size may cause an uneven cut & may be
necessary to adjust the alignment of the cutting deck.
IMPORTANT
Before remounting the wheel, apply
grease to the axle. Put the snap ring (1)
& supporting washer (2) back in place.
6.3.3 Replacing & repairing the tyres
The tyres are «Tubeless» and so all punc-
tures must be repaired by a tyre repairer
following the procedures required for this
kind of tyre. If you have to replace a tyre, make sure that any differences in their
external diameter does not exceed 8-10mm
12
6.3.4 Replacing the bulbs
(if present)
The bulbs (18W) have a bayonet
fitting and are installed in the
bulb holder which can be taken
out by turning it anti-clockwise
with pliers.
6.3.5 Replacing a fuse
The machine is fitted with
fuses (1) with different
capacities and functions.
Specifically:
– 10 A fuse = protects the
main and power circuits
of the electronic board.
When it blows, the
machine stops.
– 25 A fuse = protects the battery charger circuit. When it blows, the battery
gradually lose charge and the machine will have problems starting.
The fuse capacity is indicated on the fuse.
IMPORTANT
A blown fuse must always be replaced by one of the
same type and ampere rating, and never with one of another rating.
If problems persist, contact Your Dealer.
To Next Page
Loading...
