K110sm2e1.doc
2-5
2. 4 Connecting Power Cord
The KIP 600 operates on 100 to 240VAC.
Plug the power cord without additional voltage transmission.
Purchase a power cord separately that satisfies the following specification.
Rating: minimum 125VAC, 1A
1. Prepare a power cord (1). (The cord for 100VAC is shown)
2. Connect the power cord connector (2) to AC Inlet (3) on the rear.
WARNING
• The power cord must conform to the safety standard of the country or region in which the
machine is installed.
• Do not handle the power plug with a wet hand. It may result in receiving an electrical
shock.
• Be sure to ground the machine.
• Use a dedicated outlet for the KIP 600. Many loads on a single outlet may cause
overheating and result in a fire.
• The outlet must satisfy the following conditions;
100-240VAC, 50/60Hz, 1A or higher
1
2 3
To Next Page
Loading...
