Chapter 1 Before Use 1-6
1. 4. 2 Printer part
Subject Specification
Printing method LED Array Electro photography
Photoreceptor Organic Photoconductive Drum
Print speed 100mm per second
(Inch) 5.2ppm / E 10 ppm / D Landscape
(Metric) 4.9ppm / A0 9.5ppm / A1 Landscape
Print head LED Array
Resolution of print head
600dpi x 2400dpi
Print width Maximum 914mm / 36”
Minimum or 297mm / 11” (roll media)
or 210mm / 8.5” (cut sheet)
Print length Maximum
(Standard) 6,000mm / 19.7ft for 36” / A0 wide
(plain paper / bond)
or “5 x Standard length”
(plain paper / bond)
“2 x Standard length”
(tracing paper / vellum)
“1 x Standard length”
(film)
(Option) 200,000mm
Minimum 210mm / 8.5”
Paper feeding method 2 Roll Decks / 4 Roll Decks
Manual Feeder (single cut sheet)
Warm up time Shorter than 4 minutes
(At 23
o
C, 60%RH, the rated voltage, and plain paper is used)
First print time 22 seconds (D Landscape, Rear Stacking)
24 seconds (A1 Landscape, Rear Stacking)
(At 23
o
C, 60%RH, the rated voltage, and plain paper is used)
Fusing method Heat and Pressure Rollers
Development method Dry type non-magnetic mono-component toner
NOTE
If the print is longer than the mentioned above, its image
quality or the reliability of paper feeding is not guaranteed.
To Next Page
Loading...