Before storing the generator for an extended period -
Step 1. Be sure the storage area is free of excessive dust and humidity.
Step 2. Drain the fuel.
a). Drain all petrol from the fuel tank into an approved petrol container.
b). Turn the engine switch ON, and loosen the carburettor drain screw. Drain the petrol from the
carburettor into a suitable container.
c). With the drain screw loosened remove the spark plug cap, and pull the starter grip 3 to 4 times
to drain the petrol from the fuel pump.
d). Turn the engine switch to the OFF position, and tighten the drain screw securely.
e). Re-install the spark plug cap on the spark plug securely.
Step 3.Change the engine oil.
Step 4.Remove the spark plug and pour about a tablespoon of clean engine oil into the cylinder.
Crank the engine several revolutions to distribute the oil, and then re-install the
spark plug.
Step 5.Slowly pull the starter grip until resistance is felt. At this point, the piston is coming up on
its compression stroke and both the intake and exhaust valves are closed. Storing the
engine in this position will help to protect it from internal corrosion.
32
9. TRANSPORTING and STORAGE cont.
To Next Page
Loading...
