3 Operation of components
▆ Lock button of operating lever of bucket
It is used to lock the operating lever of bucket.
When operating lever of bucket is at the
neutral position, press down the button
forcefully to lock the operating lever.
▆Automatic resetting of bucket
When bucket is lifted to face upward, push
the operating lever toward the lifting direction
and operating lever will keep the position.
Lift the bucket on the ground to face upward
horizontally and operating lever automatically
returns to N. Then descend the moving arm
and bucket approaches the ground
horizontally.
Automatic leveling sensor
3.3 Leveler of bucket
Leveler of bucket is in same wide as bucket
so that it can level the bucket at left, right or
center position. Align the surface of leveler
and bottom of bucket.
Leveler
3.4 Engine hood ON/OFF and driver’s seat
▆ Engine hood ON/OFF
◆Engine hood ON
Pull the operating lever upward and push the
backrest of driver’s seat upward. Engine hood is
uncovered with driver’s seat. Air spring can hold
the uncovered engine hood. Therefore check if
uncovered engine hood is held by air spring tightly
before following operations are performed.
◆Engine hood OFF
Lower the engine hood to level to close it.
▆Adjustment of driver’s seat
1. Pull the adjustment handle of driver’s seat when
driver sits on the seat to move the seat forward or
lean back.
Operating lever
2. Operate the regulating valve to driver’s weight for
seating comfort.
▆Document box
Document box is in the back of backrest and used to
store Operation Instructions and magazines.
15
To Next Page
Loading...