16
CAUTION
■ DC socket can be used in AC power system.
■ Total power of AC and DC power could not be exceeded if both AC and DC
socket are used.
■ Make sure that electric circuit and plug connection is in order.
5.1 AC use
1. Start engine and make sure the output indicator light (green) remains on.
2. Make sure that appliance is shut down then connect plug into generator socket.
See fig.14.
Fig.14 Connection between appliance and generator
NOTE
■ Before connecting an appliance to the generator, check that it is in good order.
Please shut down the engine immediately and disconnect the connection to
appliance, if any abnormality, slow-down speed or unexpected stop is found.
5.2 Output and Overload Indicators, engine oil lever indicator
The green output indicator light will remain ON during normal operating conditions. If
the generator is overloaded or if there is a short in the connected appliance the green
output indicator will go OFF and the overload indicator (red) will go ON and current to
the connected appliance will be shut off.
Stop the engine if the overload indicator light (red) comes ON and investigate the
overload source. Check the engine oil level if the red oil alarming indicator comes ON.
To Next Page
Loading...
Need help?
General
