Conversion from LP Gas to
Natural Gas
Installation of the regulator
1. Turn off the main gas supply valve.
2. Disconnect 9.07 kg (20lb) LP gas fuel tank (if present).
3. Turn off all burner control valves.
4. Remove the 9.07 kg (20lb) LP gas fuel tank (if present)
from the grill cart.
5. Use an adjustable wrench to remove the LP regulator from
the manifold.
6. Use an adjustable wrench to install the Natural gas
regulator hose to the manifold and secure. Attach the
Natural gas regulator to the side panel inside the grill cart
with the two screws that are preassembled on the
regulator.
GAS CONVERSIONS
Tools and Parts for Gas Conversion
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Tools needed
Parts supplied
◼ Natural gas orifices
Parts needed
◼ Natural gas conversion kit Part Number 710-0003. See
“Assistance” section to order. The conversion kit includes:
◼ Natural gas regulator 4" W.C. (marked “Natural Gas
Regulator”)
◼ 3.0 m / 10 ft Natural gas hose with quick connector
◼ 150 mm / 5.9 in Natural gas regulator hose
◼ 6 mm nut driver
◼ 6 mm wrench
◼ Hex key
IMPORTANT: Gas conversions must be done by a qualified
installer. Before proceeding with conversion, shut off the gas
supply to the grill.
6mm
25
To Next Page
Loading...
